2013 Chevrolet Cruze
Mileage
141,138
Service Date
8/15/2024
Services Performed
- Verified customers concern. Scanned codes and found code p0496 (EVAP) system flow during non-purge. Verified oem test procedures and performed evap purge/seal función closed on evap solenoid. Oem specification for voltage on to solenoid needs to be 1.7v or lower. Started vehicle and monitored voltage graph to evap solenoid, voltage is at 2.6v after 90s. Vehicle will need evaporative emission purge solenoid valve and vent control valve for further diagnostic
- EVAPORATIVE CANISTER PURGE SOLENOID – Remove & Replace – 1.4L Eng,Turbocharger
- CANISTER VENT SOLENOID – Remove & Replace – Canister Vent Solenoid Valve – [Includes: Lowering Fuel Tank for access.]
- Rec oil change due by time and millage. front brake pads are at 3mm rec replacing front brake pads and rotors. Rotors is also extremly glazy Rec replacing oil pan gasket. Passenger side axle seal is seeping fluid Rec coolant system flush, found no anti freeze coolant is resivor conatainer Rec brake fluid flush, brake fluid is very discolored and dirty Rec replacing drivebelt due belt being worn out uneven. Belt tensioner damaged drivebelt Belt tensioner is broken causing noise to accur when vehicle is turned on. Rec replacing Belt tensioner and drivebelt together Inspected all 4 tires and found passenger rear tire with a nail puncture. Tire is patchable but tech rec replacing tire due to tire Being from 2015. Passenger rear tire is also dry rotting
- OIL PAN GASKET – Remove & Replace – Eco,LT,LTZ,1.4L Eng,Turbocharger – [Includes: R&I Catalytic Converter.]
- BRAKE SHOES &/OR PADS – Remove & Replace – w/Rear Drum Brakes,Front,Both Sides – [Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include ref
- (Combination) – DISC ROTOR – REMOVE & REPLACE
- (Combination) – DISC ROTOR – REMOVE & REPLACE
- BRAKE SYSTEM – FLUSH – [Includes: Perform ABS Automated Bleed procedure.] – [Includes: Brake System (Complete) – Inspect.]
- OUTPUT SHAFT SEAL – Remove & Replace – One Side – [Includes: Confirm Fluid temperature for level check.]
- COOLING SYSTEM – Flush
- DRIVE BELT TENSIONER – Remove & Replace – Eco,LT,LTZ,1.4L Eng,Turbocharger – [Includes: R&I Engine Mount. Includes: R&I Fender Liner.] – [Includes: Replace Belt (if necessary).]
- TIRE MOUNT & BALANCE 1 NEW ONLY
GLINDA H. gave our service a 5 star review on 8/16/2024
